Tait TB9100, Installation And Operation Manual

Page: 44 / 144

44 Installation TB9100 Installation and Operation Manual
© Tait Electronics Limited May 2006
Connecting to a Calibration and Test Unit
If you have a TB9100 Calibration and Test Unit (CTU), connect it to the
base station as follows for testing base station operation:
Note
Refer to the Calibration Software online Help or User’s Manual
and to the Calibration and Test Unit Operation Manual for
detailed information about connecting and operating the CTU.
With this set up, you can carry out the following tasks to exercise the base
station.
Figure 4.3 TB9100 to CTU connections
b Reciter rear f DC input connector
c 9-way digital I/O / serial connector g RJ-45
d Ethernet RJ-45 h 9-way port (male)
e Analog RJ-45 (audio) i 3-wire cable (TXD,RXD,GRND)
Hub
CSS
10-32 VDC
Power
Supply
CTU
b
c
d
h
g
e
f
i