Symphony C-I-CV43C, Instruction

Page: 31 / 174

3 - 6 WBPEEUI220772A0
Software Installation and Start-up
Communications Wiring
The auxiliary terminal supports Ethernet communications.
Access
Procedure PR14 shows physical footprints of the wiring access
cutouts.
Connections
Ethernet connections are made directly at the CPU. Refer to
the procedures for specific instructions.
Grounding
A system safety ground connection is located on the front of
the PEP. Use one of the studs on the inside of the auxiliary ter-
minal to connect to the building ground.
This instruction does not discuss the details of grounding sys-
tems. Good grounding practices prevent problems and reduce
system downtime. A complete and properly grounded electrical
system is vital for personnel safety, equipment protections and
normal process system operation. Digital process control sys-
tems require a single-point grounding system that has two
paths: One path for an alternating current ground (safety
ground) and one path for a direct current ground (system
common).
For detailed information on system grounding, refer to Site
Planning and Preparation .
Software Installation and Start-up
After installing the main workstation and all auxiliary worksta-
tions, install the software and configure the system. Refer to
the appropriate instructions listed in Table
1-1 to load the soft-
ware, configure and operate the system.
Installation Sequence
Refer to Figure 3-1 for the installation sequence. Each block of
the flow represents a single task that must be completed before
continuing with the sequence.