098-00564-000 Revision A3 – July, 2013
TimeProvider 2300/2700 User’s Guide
139
Chapter 3
TimeProvider 2300/2700 CLI Command Set
To provision the acceptable master table for PTP client:
set ptp client config eth1 telecom2008 master-table add
index {1 | 2} address < ipv4-address>
set ptp client config eth1 telecom2008 master-table delete
index {1 | 2}
set ptp client config eth1 telecom2008 master-table clear
To provision the PTP domain value for the Client:
set ptp client config eth1 telecom2008 domain <domain-value>
To provision the PTP Diffserv Code Point value for the Client:
set ptp client config eth1 telecom2008 dscp <dscp-value>
– If the Two-Step Clock state is Disable, a One-Step Clock is used.
To provision the announce interval for the Client:
set ptp client config eth1 telecom2008 announce-interval
<announce-interval-value>
– The interval is 2
z
seconds, where z= <announce-limit-value>.
To provision the sync interval for the Client:
set ptp client config eth1 telecom2008 sync-interval
<sync-interval-value>
– The interval is 2
z
seconds, where z= <sync-interval-value>.
To provision the delay request interval for the Client:
set ptp client config eth1 telecom2008 delay-req-interval
<delay-req-interval-value>
– The interval is 2
z
seconds, where z= <delayReqInterval-value>.
To provision the IP Header Time to Live (TTL) field for PTP packets for a Client:
set ptp client config eth1 telecom2008 ttl <TTL-value>
Note:
All master IP addresses configured in the master table
must be reachable, either by being in the same subnet as the
port (ETH1) IP address, or through a configured gateway. If
either of the master addresses is not reachable through the
network configuration, then neither of the masters will be
utilized for PTP even if one master is correctly addressed.
