Symmetricom TimeProvider 2300, User Manual

Page: 138 / 338

138 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
set ptp master config eth2 itu-g8265-1 delay-limit
<delay-limit-value>
– The interval is 2
z
seconds, where z= <delay-limit-value>.
PTP CLIENT:

To provision the active profile for PTP client:
set ptp client active-profile eth1 telecom-2008

To provision a VLAN for a master in the acceptable master table for PTP client:
set ptp client vlan-attach eth1 vlanid < 2-4094>

To provision the transport for PTP client on ETH1 port:
set ptp client config eth1 transport ethernet

To provision the service tier for PTP client on ETH1 port:
set ptp client config eth1 service-tier {sync-mask |
traffic_mask | modified_traffic_mask}

To provision the asymmetry state for PTP client on ETH1 port:
set ptp client config eth1 asymmetry state
{enable | disable}

To clear the asymmetry for PTP client on ETH1 port:
set ptp client config eth1 asymmetry clear

To provision the PTP unicast negotiation state for the Client:
set ptp client config eth1 telecom-2008 unicast-negotiation
{enable|disable}

To set the PTP unicast maximum lease duration value for the Client:
set ptp client config eth1 telecom-2008 lease-duration
<duration-value>

To set the PTP announce receipt timeout value for the Client:
set ptp client config eth1 telecom-2008
announce-receipt-timeout <timeout-value>

To provision the state for the ETH1 PTP Client port:
set ptp client config eth1 telecom2008 ptp-state {enable |
disable}