118
TimeProvider 2300/2700 User’s Guide
098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show port-control
This command provisions the sync service port, legacy port, or packet time service
ports configurations.
Command Syntax:
show port-control
Example 1:
TP2700>show port-control
Response 1:
--------------------------------------------
|# |Port |State |IO dir |Signal/Format|
|---|-------|--------|-------|-------------|
|1 |t1e1 |enable |input |t1 |
|...|.......|........|.......|.............|
|2 |pps10m |enable |output |10MHz |
|...|.......|........|.......|.............|
|3 |tod |enable |output |cisco |
--------------------------------------------
Level :
User, Config, and Admin
set port-control
Use this command to provision the sync service port, legacy port, or packet time
service port. This includes configuration of port states, port directions, port
connector types, and/or service types.
Command Syntax:
To provision the state for the T1/E1 port:
set port-control t1e1 state {enable | disable}
To provision the IO direction of the T1/E1 port:
set port-control t1e1 io {input | output}
Note:
The IO direction for the TOD and PPS10M ports are not
configurable - they are both hardcoded as “output”.
