Symantec NetBackup 5020, Routine Maintenance

Page: 39 / 60

NetBackup 5020
Routine Maintenance 4 Guide to the Routine Maintenance Using the System
Monitor Interface
Issue 01 (2010-12-10) Symantec Corporation 4-9
Parameter Description
Status The operational state of the disk.
 Online indicates that the hard disk is configured in a RAID group
and operates normally.

Hotspare indicates that the disk is hotspare disk.

Rebuild indicates that the disk is being rebuilt.
 Unconfigured(good) indicates that the hard disk is not configured
in a RAID group but operates normally.
 Unconfigured(bad) indicates that the hard disk is not configured
in a RAID group and failed.
 Failed indicates that the disk is configured in a RAID group but is
disabled.

Missing indicates that the disk is missing.

Offline indicates that the member disk in a RAID group is offline.
Capacity The disk capacity. Unit: TB .
NOTE
A 2 Terabyte disk has 2x10
12
bytes, this is represented as 1.817 TB.
Type The physical type of the disk. The type of disks in the NetBackup
5020 is
SATA .
Enclosure ID The ID of the enclosure in which the disk is.
The value of Enclosure ID is not limited. The default value is 8 .
ErrorStatus Hard disk status.

If the value of ErrorStatus is 0 , it indicates that a hard disk is
working normally.

If the value of ErrorStatus is 1 , it indicates that a hard disk is
working abnormally.
----End
Exception Handling

If a disk is in the Rebuild state, wait until it return to Online state.

If Slot Number of a present disk cannot be found in the interface, refer to “Some Disks
Can Not Be Scanned” in the
NetBackup 5020 Hardware Troubleshooting .

If a disk is in the Unconfigured (bad) , Failed , Missing , or Offline state, replace this
hard disk. For details about how to replace a hard disk, refer to "Replacing a Hard Disk"
in the
NetBackup 5020 Hardware Troubleshooting .