SWM RS 125 R 2020, Manual, Operation, Maintenance

Page: 89 / 304

EN -
26
ENGINE OIL REPLACEMENT
-
Check the O-ring (5) status and replace it if worn.
-
Replace the filter (3) and fit it on the cover (2).
-
Refit the cover (2) with the filter in the proper housing
and start the screws (1) (10 Nm, 1.0 kgm, 7.37 ft/lb).
Note
If the tapered spring (4) is out of its seat, position
its largest diameter in the seat so that it remains
in position.
After draining the oil as described above, proceed as
follows:
-
Unscrew the two screws (1) and remove the cover (2)
by slightly rotating it.
-
Remove the oil filter (3).
-
Check that the spring (4) is in its seat on the bottom
of the filter housing.
Note
Make sure that the cover holes match those of the
ducts on the crankcase side.