CWS
−
D100
−
B Welding System
Optional Equipment
2005 Swagelok Company, all rights reserved
September 2005
B-7
Load the Paper
1.
If necessary, remove the interface cable from the rear of
the printer. See Figure B-11.
2.
Turn the latch counter-clockwise to release the printer
body from the case. Remove the printer body from the
case by pulling it forward. See Figure B-6.
3.
Remove the paper roll spindle pin and used
paper spindle.
4.
Install the new roll of thermal paper and load the paper
into the feed mechanism. See Figure B-7.
a.
Place the roll between the support brackets in the
position so that the paper feeds from the top. Hold
the paper roll so that the hole in the paper spindle is
aligned with the holes in the support brackets.
b.
Fold about 1/2 in. of the leading edge of the paper
back over itself so that folded portion is facing up.
c.
Insert the paper under the silver pin and under the
top half of the paper sensor. Push the leading edge
of the paper forward into the feed mechanism.
d.
Insert the paper spindle pin in through the paper
spindle. Make sure the paper spindle pin is installed
in the orientation shown in the figure.
e.
Advance the paper with the thumbwheel until it
comes out of the front panel slot.
5.
Slide the printer back into its case.
6.
Turn the latch clockwise to secure the printer to
the case.
7.
Connect the printer cable to the connector on the rear of
the printer. See Cabling the Printer on page B-9.
8.
Run the self test described on page B-10 to ensure the
paper is installed correctly.
Figure B-6 Removing the Printer
from its Case
Latch
Figure B-7 Install Paper
Note Paper Path
Spindle
Caution!
Once the paper enters the
feed mechanism, do not pull
it back in the direction of the
paper roll. Always feed the
paper with the thumbwheel.