Maintenance
CWS
−
D100
−
B Welding System
2005
‘
Swagelok Company, all rights reserved
September 2005
6-6
4.
Remove the weld head housing screws from the
housing. Using a slight rocking motion, carefully
separate the locking ring half of the weld head housing
from the motor half. See Figure 6-8.
Take care when separating the weld head housing so
that internal components such as the safety interlock
sensor or wiring are not damaged. See Figure 6-11.
5.
Remove the rotor from the motor half of the weld head
housing. See Figure 6-9.
6.
Carefully lift the power block subassembly out of the
motor half of the weld head housing. See Figure 6-10.
Figure 6-8 Removing the Locking Ring
Half of the Weld Head Housing
Housing
Screws
Weld Head
Housing
(Locking
Ring Half)
Weld Head Housing
(Motor Half)
Figure 6-9 Removing the Rotor
Rotor
Figure 6-10 Removing the Power
Block Subassembly
Power Block
Subassembly