Svantek SV 104BIS, User Manual

Page: 61 / 180

61 SV 104BIS User Manual
6.3.4 Profile settings
The main settings where specific acoustic profile configuration can be set are located under “Dosimeter” tab.
There are already predefined pre-sets in each profile column. By choosing predefined configuration some
obvious fields will be automatically greyed. Others must be setup by the user.
There are three additional user-defined pre-sets whose names can be changed during configuration with use
of the little icon (notes with a pen) which is then enabled.
Apart from alarm DOSE threshold there are three additional source of warning alarm, which can be set. See
figure below.
Figure 6-11 Dosimeter settings - profile configuration tab
Note: Some profiles can be disabled to be seen later during measurement run (Chapter 6.3.7 ).
6.3.5 Measurement parameters settings
Within the measurement tab you can choose in which mode of operation the SV 104BIS should work:
Dosimeter, or Dosimeter with 1/1-octave or 1/3-octave analysis.
Note: Enabling 1/1 or 1/3-octave analysis shortens battery life, so take it into consideration
and double check the battery status before measurement run.
predefined
configuration
change additional source
of alarm