Suzuki WagonR+ RB310, Service Manual

Page: 483 / 3086

3E-8 REAR SUSPENSION
Coil Spring
Installation
1) Install coil springs (1) (right & left) on spring seat (2) of rear
axle as shown in figure and then raise rear axle.
2) Install shock absorber (1) lower side to rear axle (or axle
housing).
Tighten shock absorber lower bolt (2) temporarily by hand at
this step.
3) Install lateral rod (1) to vehicle body, referring to the figure for
proper installing direction of bolt (2).
Tighten nut (3) temporarily by hand at this step.
4) Remove floor jack from rear axle (or axle housing).
5) Install brake flexible hose E-ring.
6) Install LSPV spring to rear axle. Tighten LSPV adjust nut
temporarily at this step (if equipped with LSPV).
7) Install wheel (1) and tighten wheel bolts (2) to specified
torque.
Tightening torque
Wheel bolt (a): 95 N
· m (9.5 kg-m, 69.0 lb-ft)
NOTE:
When seating coil spring (1), mate spring end with
stepped part (3) of rear axle spring seat as shown.
A. Upper side
“ a ” : Small
“ b ” : Large
[A]: 2WD model
[B]: 4WD model
F: Forward