Suzuki WagonR+ RB310, Service Manual

Page: 3078 / 3086

ii)
ii)
i)
For Driver Air Bag (Inflator) Module
For Passenger Air Bag (Inflator) Module
For Seat Belt Pretensioner
1. Quarter inner trim
For Driver Air Bag (inflator) Module
1. Short deployment harness leads.
i) Release lock lever
ii) Disconnect connector
i) Pull lock lever
ii) Disconnect counter
AIR BAG SYSTEM 10B-61
DEPLOYMENT/ACTIVATION INSIDE VEHICLE
Use this procedure when scrapping the entire vehicle including the
air bag (inflator) modules and seat belt pretensioners.
CAUTION:
When vehicle itself will be used again, deploy/activate the
air bag and pretensioner outside vehicle according to
“ De-
ployment/Activation Outside Vehicle ” , for deploying/acti-
vating it inside will cause the instrument panel, glove box
and their vicinity to be deformed.
Failure to observe this CAUTION may require unneeded ve-
hicle inspection and repair.
1) Turn ignition switch to “ LOCK ” , remove key and put on safety
glasses.
2) Remove all loose objects from front seats and instrument panel.
3) [For driver air bag (inflator) module]
Disconnect contact coil connector (Yellow connector) located
near the base of the steering column.
[For passenger air bag (inflator) module]
Remove glove box from instrument panel and disconnect pas-
senger air bag (inflator) module connector (Yellow connector).
[For seat belt pretensioner]
Remove both side (driver and passenger side) center pillar low-
er trim and disconnect seat belt pretensioner (Yellow) connec-
tors from pretensioner.
4) Confirm that each air bag (inflator) module is securely mounted.
5) Check that there is no open, short or damage in special tool (de-
ployment harness). If any faulty condition is found, do not use it
and be sure to use new deployment harness.
Special Tool
(A): 09932-75030
6) Short the two deployment harness leads together by fully seat-
ing one banana plug into the other.
WARNING:
Deployment harness shall remain shorted and not be
connected to a power source until the air bag is to be
deployed and seat belt pretensioner is to be activated.
7) Connect adaptor cable (for driver air bag module and preten-
sioners) and deployment harness to air bag (inflator) module
(driver or passenger) or seat belt pretensioner (driver or passen-
ger) and lock connector with lock lever.
Special Tool
(B): 09932-78320