Suzuki UG110 2021, Service Manual

Page: 52 / 198

ENGINE 3-23
DRIVEN FACE SPRING
Measure the free length of the driven face spring. If the length is
shorter than the service limit, replace the spring with a new one.
4
Driven face spring length
Service Limit: 104.5 mm
DRIVEN FACE PINS AND OIL SEALS
Rotate the driven faces and make sure they turn smoothly.
If they stick or do not turn smoothly, inspect the lip of each oil
seal, and the sliding surface and sliding pins for wear or damage.
If any damages are found, replace the driven face with a new
one.
DRIVEN FACE
Inspect the drive belt contacting surface of both driven faces for
any scratches, wear or damage. If any damages are found, re-
place the driven faces with new ones.
REASSEMBLY
Reassemble the clutch shoe assembly and movable driven face
in the reverse order of disassembly. Pay attention to the following
points.
• Install the bearing in the fixed driven face using the special
tool.
2
09943-88211: Bearing installer
• Securely install the circlip.