Bringing the Benefits of Real-Time Data Collection to the World
Sutron Corporation, Tel: 703-406-2800,
http://www.sutron.com
213
Georgia Pacific Sampler (GPSmpl)
Inputs
DigIn
Outputs
DigOut
Description
This block samples the input (digital) at a user set interval. When the input transitions from low
(0) to high (1), increment sampler count and save the time of the event. Then delay for n
seconds (user set) and then force measurements of PH1, T1, PH2 and T2. PH1, PH2, T1 and T2
will be set up using standard blocks by tying a COMS TAG to the blocks that make the
measurement and convert the value to the desired units. When the measurements are complete
append the following record to \storage card\filename.csv in CSV format:
Date, time (edge detected), function, splcnt, ph1, t1, ph2, t2
Example:
08/27/02, 14:03:10, GPSmpl 1, 125, 5.62, 25.19, 9.73, 28.81
Use 2 right digits for ph1, t1, ph2 and t2.
If the file does not exist (because a new card has been inserted), create it. If there is a problem
creating, opening, or writing to the file, send a warning message to the report.warning.
If the digital input stays at high (1) for more than 5 minutes, write a warning message to the
report.warning.
Init splcnt to 0 when recording is turned on.
Summary of Contents for Xpert2
