Sutron Xpert2, Operation And Maintenance Manual, Page: 39 / 336

Bringing the Benefits of Real-Time Data Collection to the World
Sutron Corporation, Tel: 703-406-2800, http://www.sutron.com
29
Direct Connect Settings
This dialog is used to configure the alarm and alert settings for the direct connection.
Tx Normal Rate is the rate at which alarms are transmitted when no sensors are in alarm, and Tx
Alarm Rate is the rate used when a sensor is in alarm. They can be set to 00:00:00 to inhibit
timed alarm transmissions. Disable Alerts may be checked to prevent messages to be sent out the
port when the system enters the alert state.
Direct connections support two types of alarm messages. If SSP is detected, an SSP alarm is
sent, otherwise a simple text message is sent, and a prompt is made asking for the alarm to be
acknowledged.
Voice Modem Settings
This is the Voice Modem settings screen.
When an alert occurs each phone number is tried in sequence starting with Phone #1, until an
acknowledgement occurs. Or until the # Redials has been attempted on each number. The
Answer mode can be configured to answer in Voice, Data, or Voice & Data. The Voice & Data
mode prompts when it answers the phone to “Please press pound”. If the person dialing in
presses the “#” key on the telephone a voice message is spoken, otherwise a data carrier is
transmitted and a data connection is attempted. The Dial-in and Dial-out buttons allow the Dial-
in and Dial-out messages to be configured. Speech phrases are stored in the \Flash
Disk\speech\English directory or \Flash Disk\speech\[
language] directory depending on which
language is selected.