Bringing the Benefits of Real-Time Data Collection to the World
Sutron Corporation, Tel: 703-406-2800,
http://www.sutron.com
172
ML2x Soil Moisture Sensor (ML2x)
Inputs
<none>
Outputs
Dielectric
Moisture
Wiring
The sensor is measured single ended. Hence, connect the sensor’s V+ to any analog input
channel CH1.. CH10, and signal ground to AGND. Connect power as desired.
Description
The ML2x block is used to measure a Delta T ML2x soil moisture sensor. The following dialog
is used to configure the block for measurement:
AIO Module: select the analog module to which you connected the sensor.
AIO Channel: select the channel to which the sensor’s V+ signal is connected.
Cal Method, a1, and a0: Select the method to use for calibrating the sensor measurement to the
actual soil type. The possible selections are
Mineral
,
Organic
, and
User Cal
.
Mineral
and
Organic
are generalized calibrations for those two classes of soils, where predefined values of a0
and a1 are used to calculate moisture content.
User Cal
allows you to enter your own values for
a0 and a1 that you determine through a soil specific calibration procedure. See the ML2x manual
for more information on how perform this procedure.
Units: enter the string that should be used when displaying Moisture units.
Summary of Contents for Xpert2
