Supero SUPER S2QE6, User Manual

Page: 44 / 92

2-16
S
UPER S2QR6/S2QE6 User's Manual
Installation
PWR P Header
Connect a four-pin connector from
the power supply to the PWR P
header on the motherboard to pro-
v i d e n o t i f i c a t i o n o f a s y s t e m
power supply failure. If your sys-
tem does not have three power
supply units, you should disable
this with JP55 to prevent false
alarms.
See Table 2-20 for the pin defini-
tions of the PWR P header. (The power sup-
plies are numbered from top to bottom.)
Pin
N u m b e r
1
2
3
4
Definition
P/S1 signal
P/S2 signal
P/S3 signal
R e s e t
Table 2-20
PWR P Header Pin
Definitions
Wake-On-Ring
Wake-on-Ring allows your com-
puter to be "woken up" by an in-
coming call when in the suspend
state. Refer to Table 2-19 for pin
definitions. The S2QR6/S2QE6
meets the PCI 2.2 standard, which
provides the PME function to sup-
port WOR and WOL.
Note: You must
also have a WOR card and cable to use WOR.
Pin
N u m b e r
1
2
Definition
G r o u n d
W a k e - u p
Table 2-19
Wake-on-Ring Pin
Definitions (WOR)
RJ45 Ethernet Port
Universal Serial Bus (USB)
Two USB connectors are located
on U25; USB0 is on the bottom and
USB1 is on the top.
Note: USB0 is
shared with pins 25, 27, 29 and 31 of JF1 (see
page 2-9). Only one of these two connections
may be used at one time.
Ethernet Port
An Ethernet port is located beside
the COM2/VGA port on the I/O
backplane. This port accepts an
RJ45 cable.
USB0/USB1 Ports