Supero SUPER S2QE6, User Manual

Page: 76 / 92

S
UPER S2QR6/S2QE6 Manual
4-18
BIOS
Serial Port2 Duplex Mode
This option is enabled by the selection made in the previ-
ous Serial Port 2 Mode option. This makes the IR Duplex
Mode available, which can be set to either
Half
or
Full
.
Onboard Parallel Port
This option specifies the base I/O port address of the parallel port on the
motherboard. The settings are Auto (AMIBIOS automatically determines
the correct base I/O port address), Disabled , 378h , 278h and 38Ch .
Parallel Port Mode
This option specifies the parallel port mode. The settings are
Normal , Bi-Dir, EPP and ECP . When set to Normal, the normal
parallel port mode is used. Use Bi-Dir to support bidirectional
transfers. Use EPP (Enhanced Parallel Port) to provide asymmetric
bidirectional data transfer driven by the host device. Use ECP
(Extended Capabilities Port) to achieve data transfer rates of up to
2.5 Mbps. ECP uses the DMA protocol and provides symmetric
bidirectional communication. Note: The Optimal default setting
for this option is ECP and the Fail-Safe setting is Normal .
EPP Version
The settings are Enabled and Disabled . Note: The Optimal and
Fail-Safe default settings are N/A.
Parallel Port IRQ
This option specifies the IRQ to be used by the parallel port. The
settings are
5
and
7
.
Parallel Port ECP DMA Channel
This option is only available if the setting of the parallel port mode
option is ECP . The settings are 0 , 1 , 2 , 3 , 5 , 6 and 7 .
Onboard IDE
This option enables the IDE (Hard Disk Drive Controller) device(s) on the
motherboard. The options are Enabled and Disabled .
Auto-Detect Hard Disks
This section allows BIOS to look for and configure any hard disk drives on
your system. After highlighting this option, hit <Enter> and wait momentarily
while BIOS performs the auto-detect. You will soon see the disk drives
appear properly configured.