Supero Super P6DNF, User Manual

Page: 84 / 106

A-2
SUPER P6DNF/P6SNF User’s Manual
NOTE
The errors listed below may appear during operation.
5. Undefined Error - Command Aborted — An error
condition has occurred which the program cannot
identify.
6. Address Mark Not Found — The address mark (initial
address) on the hard disk could not be found.
7. Requested Sector Not Found — The sector currently
requested on the hard disk could not be found.
8. Reset Failed — The program issued a reset command
to the hard disk, but this command did not properly
reset the hard disk.
9. Drive Parameter Activity Failed — The program has
sent a reset command to the controller, followed by
the drive parameters. Using the parameters sent to
it, the controller is not getting a response from the
hard disk drive. Check to see if the drive type
selected in the ‘Standard CMOS Setup’ is correct for
the disk drive being used.
10. Bad Sector Flag Detected — The program has tried to
perform an operation on a sector which has been
flagged (i.e., marked as “bad”).
11. Bad ECC on Disk Read — When the program attempts to
write to the disk, it also calculates an ECC (Error
Correction Code) value for the data being written.
This ECC value is written to the drive and then read
back. If the value read back is different from the one
calculated, then, this error will occur.