Supero Super P6DNF, User Manual

Page: 103 / 106

E-3
Appendix E: BIOS Non-Fatal Error Messages
10. Keyboard Error — The BIOS has encountered a
timing problem with the keyboard. Make sure you
have an AMI keyboard BIOS installed in your system.
You may also set the ‘Keyboard’ option in the BIOS
SETUP Program, Standard CMOS Setup to “Not
Installed,” which will cause the BIOS to skip the
keyboard POST routines.
11. KB/Interface Error — The BIOS has found an error
with the keyboard connector on the system board.
12. CMOS Memory Size Mismatch — If the BIOS finds
the amount of memory on your system board to be
different from the amount stored in CMOS, this error
message is generated. Run the BIOS SETUP
Program to correct this error.
13. FDD Controller Failure — The BIOS is not able to
communicate with the floppy disk drive controller.
Check all appropriate connections after the system is
powered off.
14. HDD Controller Failure — The BIOS is not able to
communicate with the hard disk drive controller.
Check all appropriate connections after the system is
powered down.
15. C: Drive Error — The BIOS is not receiving any
response from hard disk drive C. It may be
necessary to run the Hard Disk Utility to correct this
problem. Also, check the type of hard disk selected
in the Standard CMOS Setup of the BIOS SETUP
Program to see if the correct hard disk drive has
been selected.
16. D: Drive Error — The same error has occurred with
hard drive D. Follow the procedures in Error #15 to
correct the situation.