Supero Super P6DNF, User Manual

Page: 32 / 106

2-12
SUPER P6DNF/P6SNF User’s Manual
2-6 Installing/Removing the SIMM Modules
SUPER P6DNF/P6SNF can accommodate a maximum of 1 GB of
on-board memory, using standard 72-pin SIMM memory modules.
You can use any 1 MB, 2 MB, 4 MB, 8MB, 16MB or 32MB Fast Page
Mode or EDO SIMM modules. You can use 32-bit or 36-bit
m e m o r i e s .
There are no jumpers to configure the on-board memory. Two slots
of memory totaling 8 MB are required for a minimum system con-
figuration. Memory banks must contain two 72-pin single-sided or
double-sided SIMM modules. Memory timing requires 60ns fast
page devices.
Refer to Figure 2-1 and the instructions below for installing or re-
moving SIMM modules.
CAUTION
Exercise extreme care when installing or removing the
SIMM modules to prevent any possible damages.
SIMM Module Installation
1. Insert SIMM modules in Bank 0 through Bank 3 as required
for the desired system memory.
2. Insert each SIMM module into its socket at an angle away
from the CPU sockets. The component side of the SIMM
modules must face the CPU sockets.
3. Gently press the SIMM module in the direction of the CPU
sockets until it snaps upright into place in the socket.