Sun Microsystems Sun Netra CP3260, User Manual

Page: 48 / 144

2-12 Netra CP3260 Blade Server User’s Guide • April 2009
1. Locate the FB-DIMM connectors on the Netra CP3260 blade server.
Select the connectors where you will install the memory module (
FIGURE 2-1
). If
you need to replace an existing memory module with a new module, see
Section 2.5.1.1, “To Remove FB-DIMM Memory Modules” on page 2-10 for
instructions on removing the FB-DIMM module.
2. Remove the FB-DIMM from its protective packaging, holding the module only
by the edges.
3. Insert the bottom edge of the FB-DIMM into the bottom of the slot’s
hinge-style connector (see
➊
in
FIGURE 2-3
).
The socket and module are both keyed, which means the module can be installed
one way only. With even pressure, push simultaneously on both upper corners of
the FB-DIMM until its bottom edge (the edge with the gold fingers) is firmly
seated in the connector.
FIGURE 2-3
Installing a FB-DIMM Memory Module
Caution – Do not rock the FB-DIMM into place. Ensure that all contacts engage at
the same time. You will feel or hear a click when the FBDIMM properly seats in the
connector.