Sun Microsystems Sun Blade 100, Service Manual

Page: 106 / 222

6-4 Sun Blade 100 Service Manual • October 2000
FIGURE 6-2
Removing and Replacing the Diskette Drive Cable Assembly
6.2.2 Replacing the Diskette Drive Data Cable
Assembly
1. Position the diskette drive data cable assembly into the chassis (
FIGURE 6-2
).
2. Close the two cable routing clips (
FIGURE 6-2
).
3. Connect the diskette drive data cable assembly connectors to the following:
■
Riser board (J9)
■
Diskette drive
Note – Ensure that the cable assembly connectors are properly oriented by aligning
the connector keys.
4. If you moved the fan assembly, replace it. See Section 6.4.2 “Replacing the Fan
Assembly” on page 6-17.
5. Detach the wrist strap, replace the system cover, and power on the system as
described in Chapter 9 “Finishing Component Replacement.”
Diskette drive data cable
Cable routing clip
J9 connector