Sun Microsystems Sun Blade 100, Service Manual

Page: 100 / 222

5-6 Sun Blade 100 Service Manual • October 2000
5.6 Removing the System Cover
Remove the system cover as follows (
FIGURE 5-2
):
1. Using a No. 2 Phillips screwdriver, remove the two screws securing the system
cover to the chassis.
2. Slide the system cover toward the rear of the system until the cover tabs release.
3. Lift the system cover straight up. Set it aside in a safe place.
FIGURE 5-2
Removing the System Cover
5.7 Attaching the Antistatic Wrist Strap
1. Unwrap the first two folds of the wrist strap; wrap the adhesive side firmly
against your wrist.
2. Peel the liner from the copper foil at the opposite end of the wrist strap.
3. Attach the copper end of the wrist strap to the chassis (
FIGURE 5-3
).
4. Disconnect the AC power cord from the system.