Suez Sievers UPW Boron Analyzer, Operation And Maintenance Manual

Page: 43 / 104

SUEZ © 2018 43 of 104 DLM 71000-03 EN
Rev. B
Chapter 3: Installation
Starting the Analyzer
If no modifications to the default settings are needed at this time, begin analysis by pressing the Start key
on the front of the Analyzer and proceed to “Rinsing Down the Analyzer” below.
Enabled / Disabled
Stream 1: Enabled
Stream 2*: Disabled
Stream 3*: Disabled
Stream 4*: Disabled
Enabled or Disabled Chapter 5
Samples / Stream
Stream 1: 10
Stream 2*: 10
Stream 3*: 10
Stream 4*: 10
Up to 240, in increments of 5 Chapter 5
I/O SETTINGS
Binary Inputs Disabled
State (start or stop); Stream X (enables or
disables a specific stream)
Chapter 6
AC Frequency 60Hz 50Hz Chapter 6
Analog Outputs (one
per stream)
No Output Low Output; Boron; Calibrate Chapter 6
Analog Standby
Level
2mA 0mA; 4mA Chapter 6
Alarm Outputs Off
Boron; Resistivity Warning; Resistivity
Error; New Boron Reading; Fatal Error;
State (running or idle)
Chapter 6
Serial Port 19200 Baud Rate 2400; 4800; 9600; 38400; 57600; 115200 Chapter 6
Binary Outputs Off
Boron; Resistivity Warning; Resistivity
Error; New Boron Reading; Fatal Error;
State (started or stopped)
Chapter 6
Printer Type Seiko DPU-414 Citizen iDP 3110; No Printer Chapter 6