Studer OnAir 500 Modulo, Operating Instructions Manual

Page: 82 / 118

OnAir 500 Digital Mixing Console
Dynamics 6-5
Date printed:
30.07.04
6.7 Dynamics Presets
6.7.1 Storing and Naming a Dynamics Preset
Once you have programmed the dynamics processor to your requirement,
you may store it for later recall by proceeding as follows:
1
Make sure the DYN button is selected.
2 Press the flashing PRESETS button. The LC display will read:
1:<Empty>
Dyn Prset Store
3 Use the PARAMETER encoder to locate the preset memory location you
would like to save to.
4
Now use the
i
(down) arrow button to select the Dyn Prset Store line
in the display. The PRESETS button will begin to flash.
5 Press the
PRESETS
button to select the Store To: page; you may also use
the PARAMETER encoder to select a preset memory location.
6 Press the flashing
DYN
button.
7
You will be prompted to rename the preset, which you may do using the
PARAMETER encoder and the
t u z i
arrow buttons.
8 Once you have finished renaming the preset, press the DYN button again to
store the preset.
6.7.2 Recalling a Dynamics Preset
You may recall a dynamics preset and assign it to any channel. To recall a
dynamics preset, proceed as follows:
1 Make sure the DYN button is selected.
2 Press the flashing
PRESETS
button. The LC display will read:
1:XXXXXXXXX
Dyn Prset Recall
3 Use the
PARAMETER
encoder to select the dynamics preset you want to re-
call.
4
Press the
i
(down) arrow button to select the Dyn Prset Recall line of
the LC display.
5
Now press the SELECT button on the channel to which you want to assign the
dynamics preset.
6
Press the flashing PRESETS button to recall the dynamics preset to the se-
lected channel.