Studer OnAir 500 Modulo, Operating Instructions Manual

Page: 58 / 118

OnAir 500 Digital Mixing Console
Menu Pages 4-15
Date printed: 10.08.05
the designated talkback microphone signal to an external talkback routing
system.
Any of the four line/cleanfeed outputs can be configured as mono direct
outputs for a selected channel (e.g. for use with a single microphone), or as
a “mono summed” output if the channel has been set-up as a stereo channel
(e.g. a CD player). A
stereo direct output can also be achieved by linking the
line outputs 1-2 and 3-4.
Configuring a Channel as a Direct Output:
1
Press the SETUP button found below the LC display. This will enter the setup
mode.
2
Use the
PARAMETER
encoder to scroll through the menu pages to locate the
Line/CF Outputs
menu page. The SETUP button will flash upon selec-
tion.
3 Press the SETUP button to enter the line/CF outputs set-up mode. The LC
display will show:
Line Output: 1 - >
Outs 1+2 Mono
4
Use the PARAMETER encoder to select which of the line/cleanfeed outputs
you want to use.
5 Press the i (down) arrow button and use the PARAMETER encoder to choose
whether line/cleanfeed outputs 1-2 and 3-4 are configured to operate as indi-
vidual mono outputs or as stereo pairs.
6 Press the u (right) arrow button to enter the channel selection page. The LC
display will show:
< - Mode:Direct OP
Channel 1
7
Press the
z
(up) arrow button and then use the
PARAMETER
encoder to select
“
Direct OP
” mode (the other choices are “
Prog Mix-
”, “
Aud Mix-
”,
“
Cont Talk
”, and “
Unsourced
”).
8 Press the i (down) arrow button and then use the PARAMETER encoder to
select which channel you want to send to the selected line/cleanfeed output.
9
Pressing the SETUP button will exit this menu. However, the SETUP button will
still flash, the next menu can be selected for adjustment. To exit completely,
press one of the
DYN , EDIT , or PRESETS buttons twice.
Configuring a Channel as a Cleanfeed Channel:
The four line/cleanfeed outputs can be used to supply four mono or two stereo
cleanfeed outputs.
The selected line/cleanfeed output will contain either the PROG or AUD pro-
gram output signal
minus
the designated channel.