Stryker 3002, Maintenance Manual, Page: 66 / 245

Return To Table of Contents
66 3006-409-006 REV C www.stryker.com
Service Information
28. Once the lock button is released, the message
“Height Limit Set” will be displayed and the user will
be returned to the screen in Figure S-30 (The height
limits are now burned in.) The “SET” text indicates
that the limits are set. The process is similar for the
Burn-in Fowler routine.
Once the Burn-in Fowler item is selected, the
message “Set Fowler to Lower Limit” is displayed.
Press and hold the “Enter” button to set the lower
limit. The message “Set Fowler to 30
0
” will now be
displayed. Once this is completed, the message
“Set Fowler to Upper Limit” will be dislpayed.
Once all three limits are burned in, the message
“Fowler Calibration Complete” will be displayed for
two seconds and the user will be returned to the
Bed Config. menu.
29. Once all Bed Config. items are set, the main
screen will be displayed as in Figure S-31.
Burn-in Fowler
Burn-In Limits
Height Limits [SET]
 = Enter X = Exit
Figure S-30
Bed Type [S3]
Bed Config.
Burn-in [SET]
Bed Options [SET]
Serial Number [SET]
Figure S-31
30. Good to note:
• Any item may be adjusted at any time.
• If the Bed Type is changed, the serial number and burn-in limits are cleared and the process needs to be repeated
by the user.
• If the Zoom options are changed, the burn-in limits are cleared and the process needs to be repeated by the
user.
• The user must cycle power to the bed to exit the Bed Config. mode.
• The user will not be able to exit the Bed Config. mode without setting all items (with the exception of the fowler
limits). I.E., the user must choose the Bed Type, set all options to either ON, OFF or some variety of the option,
enter the serial number and burn-in the height limits in order to exit the Bed Config. menu on a power cycle.
SOFT CONFIG. PROCEDURES (CONTINUED)