Stryker 3002, Maintenance Manual

Page: 65 / 245

Return To Table of Contents
www.stryker.com 3006-409-006 REV C 65
25. Hitting “Exit” on the footboard panel while in
the Serial Number screen will return the user to the
Bed Config main menu as shown in Figure S-27.
Note that the user can see the state of the items
previously set.
26. Once the Burn-in item is selected, the screen
in Figure S-28 will be displayed. The Burn-in Height
item will walk the user through the burn-in height
routine; and, similarly, the Burn-In Fowler item will
walk the user through the burn-in fowler routine.
27. The burn-in height routine will display different
messages depending on if the user chooses to
activate the Zoom/Batt. option.
If the Zoom or
Battery Backup option is activated
, the message
in Figure S-29 will be shown on the screen. If the
Zoom/Battery Backup option was deactivated, then
the message would display: “Put Bed in Low Height.”
Drive the bed to its high or low height (depending
on the message displayed) and hold the Bed Motion
Lock. The screen will display the message “Hold to
Set Height Limits.” Once the lock button is held for
two seconds, the message “Release Button” will
flash.
Service Information
Burn-In
Bed Config.
Bed Type [S3]
Bed Options [SET]
Serial Number [SET]
Figure S-27
Burn-in Height
Burn-In Limits
Burn-in Fowler

= Enter X = Exit
Figure S-28
Message
Put Bed in High Height
Figure S-29
SOFT CONFIG. PROCEDURES (CONTINUED)