Stryker 3002, Maintenance Manual

Page: 24 / 245

Return To Table of Contents
24 3006-409-006 REV C www.stryker.com
3. Use the Up and Down Arrow buttons to highlight the desired units and
identify whether you want them locked or unlocked.
4. Press and hold the Enter/Check button to select and save the new
state.
5. The following screen message will be displayed:
“Save Successful” .
6. The Scale Units screen will reappear after two seconds and the new
setting will be highlighted.
7. Pressing the Exit/X button will return you to the Maintenance Menu
screen without saving the new state.
About Product
The display will indicate the current bed configuration including the bed type, bed options, serial number and the
software versions for all software targets connected on the internal CAN network. For example, the menu will list
out the bed configuration as follows:
To view this information:
1. In the Maintenance Menu, select the About item then press and hold the “Enter”/Check button.
2. The About Screen will be displayed.
3. Use the Up and Down Arrow buttons to scroll through the information if it does not fit on one screen.
4. Press the “Exit”/X button to return to the Maintenance Menu screen.
5. The Type information should indicate, depending on the options:
“Zoom”, “Scale”, “Bed Exit” (if Mulitzone,
“Zone Control” will be printed under the “Bed Exit” text) and “Awareness”.
Exit Menu
• This feature allows the operator to exit the menu back to the previous screen.
• When this menu item is selected the screen will exit to the “Status” screen.
Maintenance Menu (Continued)
Figure 41
Maintenance Menu Guide
Type and Options:
S3
- Zoom/Batt.
- Scale
- Bed Exit
Zone Control
- Awareness
Serial Number:
080115000
Software:
3006-307-905_F
v.1.1.022
3006-500-905_E
v.1.1.016