Still RX60-35/600, Original Instructions Manual

Page: 418 / 470

5
Maintenance
Preserving operational readiness
Checking the hydraulic oil level
– Park the truck securely.
CAUTION
Risk of component damage!
If you remove the battery male connector when the
key switch is switched on (under load), an arc will be
produced. This can lead to erosion at the contacts,
which considerably shortens their service life.
– Switch off the key switch before the battery male
connector is disconnected.
– Only disconnect the battery male connector with
the key switch switched on in an emergency.
– Disconnect the battery male connector.
– Remove maintenance lid or bottom plate.
CAUTION
Hydraulic oils are hazardous to your health and are
under pressure during operation.
– Note the safety regulations in the "Hydraulic
fluid" chapter.
CAUTION
Risk of damage to components!
Remove connector for drive unit.
1
2
6210_700-002
– Unscrew breather filter (1).
– Check the oil level on the oil dipstick. The oil
level must be between the markings (2).
– If the oil level is too low, pour hydraulic oil of
the correct specification as specified in the
maintenance data table into the filler neck.
– Fill the hydraulic oil no higher than the upper
marking on the oil dipstick.
NOTE
Use a funnel.
ENVIRONMENT NOTE
Carefully collect up any spilled oil and dispose
of it in an environmentally friendly manner.
– Screw in the breather filter with oil dipstick.
– Close maintenance lid or bottom plate.
404 171533 EN - 02/2019 - 19