Operation
4
Display messages
7325_003-056_en_V2
F1
F2
SAFETY BELT message
DANGER
Risk of fatal injury in the event of falling
from the truck if it tips over!
If the truck tips over, the driver is at risk
of injury even if a restraint system is
used. The risk of injury can be reduced
by using a combination of a restraint
system and a seat belt. In addition,
the seat belt protects against the
consequences of rear-end collisions
and falling off ramps.
– We recommend that you always
use the seat belt.
This device (variant) ensures that if the
seat belt is not being used or is being used
incorrectly, the truck will only drive slowly or
(optionally) will not drive at all.
Depending on the configuration selected, the
working hydraulics functions (lifting/tilting) are
either available as normal, slowed down or not
available at all.
The
SAFETY BELT
message with the restric-
ted driving and lifting functions is triggered by
the following circumstances:
• Seat belt not worn and driver's seat occu-
pied
• The seat belt is constantly fastened but the
driver's seat is only occupied afterwards
• The seat belt is not fastened until after the
key switch has been switched on
• The seat belt is unfastened while driving
– If the
SAFETY BELT
message appears,
fasten the seat belt in accordance with the
regulations.
The truck can again be operated without
restrictions.
If the seat belt is released while driving, the
truck will be limited to low driving speeds or will
be braked to a halt.
171533 EN - 02/2019 - 19
287
Summary of Contents for RX60-35/600
