Still FS-X33, Original Instructions Manual

Page: 36 / 94

3
Overview
Safety equipment
change at least once. In normal operation, this
happens automatically during operation. If
this is not the case, a corresponding message
appears on the display. The seat switch must
be released and then actuated once again.
If the seat switch is defective, a display will
appear.
If one of the switches stops working during
operation, the truck is braked to a standstill or
to a speed of 2.5 km/h, according to truck type,
and a corresponding message appears in the
display.
The seat switch monitors whether or not a
driver is at his workplace. The seat switch
must be actuated together with the foot
switch and either the accelerator pedal or
the operating devices for the hydraulics in the
correct sequence. The seat switch and foot
switch must always be actuated first. Only
then can either driving or one of the hydraulic
functions be selected.
If the sequence is not correct, one of these
messages will appear in the display:
•
SEAT!
•
SEAT SEQUENCE!
•
PEDAL/SEAT SEQUENCE
The function of the seat switch itself is also
monitored. If the switch is not actuated at least
once within 8 hours, the controller assumes
there is a defect and issues this message:
•
NO SEAT!
If the message is still displayed after the
switch has been pressed once, call the service
department.
30 51328042507 [EN]