Use
4
Putting Out of Commission and Storage
Recommissioning after storage
If the truck has been stored for more than
six months, it must be checked carefully
before being recommissioned. This check
is similar to the workplace accident prevention
inspection. It is therefore necessary to check
all points and systems that are important for
truck safety.
Carry out the following operations:
– Clean the truck thoroughly.
– Grease all hinges and joints.
– Check the condition and density of elec-
trolyte, and, if necessary, recharge the
battery.
– Check that there are no traces of conden-
sation water in the hydraulic oil. Drain if
necessary.
– Carry out the same maintenance work as
for the first time it was commissioned.
– Commission the truck.
– In particular, check the following during
start-up:
• traction, control and steering
• brakes (service brake and parking brake)
• lifting device
1170 801 15 09 [EN]
75
Summary of Contents for EXG-10
