Still EXG-10, Original Instructions Manual

Page: 104 / 152

5
Maintenance
Maintenance every 1000 hours
Maintenance every 1000 hours
Checking the condition and tightness
of wheels
Condition of wheels
– Raise the truck so that the wheels are off the
ground and carefully support the machine
on suitable blocks.
– Check that the wheels rotate freely and
remove all the coiled wires that may obstruct
them.
– Check the extent of tread wear.
– Replace wheels that are worn or damaged.
– Carry out this operation at the front, then the
rear.
CAUTION
Deterioration or destruction of the equipment
It is essential to remove any wire that may have
wound round the wheel hubs and bearings.
Wheel tightness
– Raise the truck so that the wheels are off the
ground and carefully support the machine
on suitable blocks.
– Remove the front hood.
– Check the tightness of the nuts on the drive
wheel, torque setting: 140 Nm.
– Check the tightness of the mounting screws
on the load wheels, torque setting: 50 Nm.
– Check the tightness of the stabiliser wheel
axle, torque setting: 15 Nm.
WARNING
Risk of serious injury and/or serious damage to
equipment.
It is recommended that gloves are worn when
replacing the drive wheel.
98 1170 801 15 09 [EN]