Instruction Manual for Sicurao pesa Hospital Bed
Page
38
4.3.4
Linen Holder
This bed is equipped with a linen holder at the foot end of the bed.
Pull the linen holder out from under the
mattress base with a slight jerk.
- A gallery rail is attached to the linen holder.
If necessary, raise the gallery rail to an upright
position. This helps to hold the bedding in
place.
The control box for carrying out motorised adjustments is
also located in the linen holder (see Chapter
Fehler!
Verweisquelle konnte nicht gefunden werden.
).
4.3.5
Extending the Mattress Base
The mattress base can be extended by 280mm at the foot end:
1.
With both hands, grasp the grey
plastic levers
[8]
located on the
left and right side under the foot
section.
2.
Press both of the plastic levers
[8]
down with the thumb of each
hand and pull the bed extension
out towards you as far as
possible.
3.
Let go of both plastic levers
[8]
and slightly pull the foot section
in the extension direction out
and then back in until it locks
into place with an audible
"click".
The maximum load-bearing capacity of the linen holder is 15 kg.
Do not lean on the linen holder!
Do not sit on the linen holder!
When removing and re-inserting the control box, pay
attention to the cable routing.
Ensure that the cable cannot be caught, stretched, crushed
or otherwise damaged.
Always slide the linen holder back into place after use > risk of
tripping!
8
click