6-6
122998-741
Operator Manual
Routine Maintenance
6.3.2 Clean Washer Interior
1.
Wash chamber with a mild detergent solution.
2.
Rinse with tap water and dry with a lint-free cloth.
3.
If interior is stained, use a general purpose cleaner to remove
general stains or a stainless-steel stain remover for stubborn
stains, as follows:
a.
Using a damp cloth or sponge, apply cleaner in a back and
forth motion, in same direction as surface grain.
b. Thoroughly wipe off cleaner.
c.
Polish surface with a clean, dry and lint-free cloth.
6.3.3 Clean Spray Jets and
Header
1.
During unit operation inspect each nozzle to detect debris.
2.
Insert a wire (smaller diameter than jet orifice) into jet nozzles
and push debris through nozzles into header.
NOTE: Jet nozzles are factory aligned to provide maximum
washing efficiency. Do not move spray jets when cleaning.
3.
Remove flush plugs from bottom of spray headers (see Figure 6-2).
4.
Manually fill sump with water and run pump for 30 seconds to
flush loosened debris from spray headers.
5.
Replace flush plugs.
CAUTION – POSSIBLE EQUIP-
MENT DAMAGE: Never use
rinse-dry chamber as a sink.
Under no circumstances
should waste water be poured
into it as water could overflow
drain and damage delicate
components.
Figure 6-2. Spray Header
