5-13
Cycle and Control Value Programming
Operator Manual
122998-741
3.
Press
CHANGE VALUES
. First Change Values screen appears:
CHANGE CYCLE NAME
CYCLE 1
__Indicates flashing position.
At this point, operator has access to all phase values screens of
selected cycle and operating values screens. Sequence and
procedures for changing cycle phase and operating values are
same as previously discussed.
NOTE: If Access Code feature is enabled and selected cycle is
not locked out, only operating values will be protected by access
code. Access code screen sequence will occur after Date and
Time screen. After entering correct access code, operator has
access to remaining operating values screens.
5.6 Review and Print
Specific Cycle Program
All cycle programs may be reviewed by accessing Cycle Review
mode when a cycle is not in progress. Cycle Review mode allows
user to review and printout cycle phases and values programmed for
specific cycle selected.
1.
Press
CYCLE MENU
touch pad until desired cycle menu
appears on screen.
CYCLE 5
CYCLE 6
CYCLE 7
CYCLE 8
__Indicates flashing position.
2.
Press
SELECT CYCLE
touch pad until desired cycle name
flashes.
CYCLE 5
CYCLE 6
CYCLE 7
CYCLE 8
__Indicates flashing position.
3.
Press
REVIEW CYCLE
touch pad to access Cycle Review
mode, and review first phase of selected cycle.
CYCLE 6
HTW
PREWASH
T=01:00
4.
Continue to press
REVIEW CYCLE
touch pad to sequentially
review each phase of selected cycle.
CYCLE 6
SP=180.0F
FINAL RINSE
T=01:00
5.
Press
REVIEW CYCLE
touch pad until print message appears
on screen.
PRINT CYCLE VALUES?
REVIEW = YES
STOP = NO
