3-2
122998-741
Operator Manual
Component Identification
3.2 Power Switch
POWER-OFF/STANDBY
switch, located behind printer door,
includes two settings which direct operation of control (see Figure 3-2).
•
POWER
- Press top portion of rocker switch to initialize controls
and enable unit operation.
•
OFF/STANDBY
- press bottom portion of rocker switch to initiate
Shutdown cycle and turn off all ac power to control (Standby
mode). While in Standby mode, unit operation is not possible.
NOTE: Control should be placed in Standby mode after last cycle
of day and when washer is not in use for an extended period of
time.
3.3 Printer
Printer records pertinent cycle data on 2-1/4 inch wide single-ply
thermal paper. Refer to
, for infor-
mation on changing paper roll and storing thermal paper.
Printer is located inside of load-side control panel, to the right of load
door.
Printer Function Switch controls the following two printer functions:
•
- Pressing top portion of Printer Function Switch
generates a printout of alkaline and acid detergent setpoints (if
conductivity option) and all RTD temperatures (actual water
temperature).
•
PRINT VALUES
- Press bottom of Printer Function Switch to
generate a complete printout of all cycle values.
3.4 Load-Side Control
Panel
Load-side control panel is used to direct all washer functions. Oper-
ator may program specific cycles, review and select cycles, start,
stop, or reset cycle operation, extend or by-pass cycle phases, and
monitor cycle performance from control panel.
Standard load-side control panel includes a printer.
3.4.1 Display Screen
Two-line alpha-numeric screen displays cycle program data on
demand, in-cycle performance data, and operator instructions. Dis-
play screen also indicates certain abnormal conditions that may
occur during a cycle (see Figure 3-2).
