14
A100K10788
IP Master Station Installation & Configuration
2.9 IP DAK-48 Unit
The IP DAK-48 unit expands the IP Flush Master station with an
additional 48 Direct Access Keys.
"
Before installation, disconnect power from the IP Flush Master station
The accompanying RJ45-RJ45 cable is used to install the DAK unit on an
IP Flush Master station. This cable has an RJ45 plug at both ends. The
two ends are interchangeable. Up to two DAK units can be installed per
station. Each DAK unit has two RJ45 ports, one located on the left side
and one on the right side.
To install the IP DAK-48 Unit:
1. Plug one end of the RJ45-RJ45 cable into the RJ45 port on the right
of the station (when the station is viewed from the front).
2. Plug the other end of the RJ45-RJ45 cable into the left (when the unit
is viewed from the front) RJ45 port on the DAK unit.
Figure 12 Installing the IP DAK-48 Unit
To add another DAK unit, plug one end of an RJ45-RJ45 cable into the
RJ45 port of the installed unit and plug the other end into the RJ45 port of
the new unit.
-
-
+
+
STENTOFON
STENTOFON
IP DAK-48 Unit
IP DAK-48 Unit
IP Flush Master Station
STENTOFON
RJ45 - RJ45 Cable
RJ45 - RJ45 Cable
