Instruction Manual
49
2.
Click on the
Apply
button to apply the LAG Port settings.
Viewing LAG Port Status
•
On the
LAG Port Status
page, the following information will be displayed:
•
LAG
: Displays the LAG number.
•
Description
: Displays the current description.
•
Port Type:
Displays the current port type.
•
Enable State:
Displays the current enable state.
•
Speed:
Displays the current speed.
•
Duplex:
Displays the current duplex mode.
•
Flow Control Config:
Displays the current flow control configuration.
•
Flow Control Status:
Displays the current flow control status.
Configuring LACP System Priority Settings
The
LACP Settings
page is used to configure the LACP system priority settings.
1.
On the
LACP Setting
page, enter a system priority value (1 - 65525) in the
System Priority
field.
•
System Priority
: A value which is used to identify the active LACP. The
Managed Switch with the lowest value has the highest priority and is
selected as the active LACP peer of the trunk group.
2.
Click on the
Apply
button to apply the LACP setting changes.
Configuring LACP Port Setting
1.
On the
LACP Port Settings
page, select a port from the
Port Selection
drop-
down list that the LACP settings will apply to.
2.
Enter a priority value in the
Priority
field.
•
Priority
: Controls the priority of the port. If the LACP partner wants to form
a larger group than is supported by this device, this parameter will control
which ports will be active and which ports will be in a backup role. A lower
number means greater priority.
3.
Select a
Timeout
method.
•
Timeout
: The Timeout controls the period between BPDU transmissions.
Short will transmit LACP packets each second, while Long will wait for 30
seconds before sending an LACP packet.
