Instruction Manual
116
Applying STP Port Settings
1.
On the
STP Port Setting
page, select a port number you want to apply STP Port
settings to.
2.
On the
DoS Protection
field, select whether to enable or disable STP port
settings.
3.
Click the
Apply
button.
Viewing DoS Port Status
•
On the
DoS Part Status
page, the following information will be displayed:
•
Port Select:
Displays a list of port numbers.
•
DoS Protection:
Displays whether STP Port Settings are enabled or disabled
on the corresponding port.
Storm Control
Storm Control settings allow you to configure settings that affect the three types
of Storm Control, unknown unicast storm rate control, unknown multicast storm
rate control, and a broadcast storm rate control. These Storm Control types only
affect flooded frames, i.e. frames with a (VLAN ID, DMAC) pair not present on the
MAC Address table.
Applying Storm Control Settings
1.
On the
Storm Control Global Setting
page, select a
Unit
of measure either:
•
pps
: Packets per second
•
bps:
Bits per second
2.
On the
Preamble & IFG
field, select whether to exclude or include Inter-Frame
Gap (IFG).
3.
Click the
Apply
button.
Viewing Storm Control Global Information
•
On the
Storm Control Global Information
page, the following information will
be displayed:
•
Unit:
Displays the unit of measure selected to measure the Storm Control
Rate.
•
Preamble & IFG:
Displays whether or not IFG is excluded or included.
