Star Micronics WinType 4000, Technical Manual

Page: 169 / 180

CHAPTER 6
PARTS LIST
HOW TO USE PARTS LIST
(1) DRWG. NO.
This column shows the drawing number of the illustration.
The screws and retaining rings used all section are described in “Section 6. List of Standard Fasteners”.
(2) REVISED EDITION MARK
This column shows a revision number.
(3) PARTS NO.
Parts numbers must be notified when ordering replacement parts.
Parts described as “NPN” have no parts number and are not in stock, i.e., unavailable. When these parts are
necessary, place orders for parts (assemblies or units) of higher level. Their drawing numbers are described in
the “ASSY” column.
(4) PARTS NAME
Parts names must be notified when ordering replacement parts.
(5) Q’TY
This column shows the number of the part used as indicated in the figure.
(6) REMARKS
When there are differences in the specifications of the fuse, destinations, etc., the differences are described in
words or indicated by two letters.
US ... U.S.A. EC ... EC (with Germany) UK ... United Kingdom
HK ... Hong Kong AS ... Australia
“WITH 2-6” shows that drawing numbers 2, 3, 4, 5 and 6 are included.
“J1
↔
J2, J3” attached to parts such as harnesses and wires, shows that one end of a harness or wire is Jack J1
of a connector and another is its J2 and J3.
For the locations of connectors (P/J), refer to “Connector P/J Arrangement, Section 4, Chapter 4.”
(7) RANK
Parts marked “S” are service parts. Service parts are recommended to be in stock for maintenance.
(8) ASSY
This column shows drawing numbers of higher-level parts (assemblies or units) of those described as “NPN”
in the “DRWG. NO.” column.
6