Standard Horizon CPF180I, Owner'S Manual

Page: 29 / 166

CPF180i and CPF300i Page 31
3. CONTROLS AND INDICATORS
NOTE
This section defines each control of the CPF180i or CPF300i. For instructions, refer to Getting
Started and Advanced Settings sections of this Owner's Manual.
NOTE
Throughout this Owner’s Manual same conventions are used. See the legend below:
[MENU] If you see brackets around a bold and capital letter word this refers to a key press.
[C
HART
] If you see brackets around a bold and small capital letter word this refers to a Soft Key
press.
GENERAL SETUP When a word(s) is bold capital letters and underlined, this refers to a menu
selection item.
3.0 CONTROLS AND CONNECTIONS
The CPF180i or CPF300i is controlled by using the keys located on the front panel. These
labeled keys are dedicated to specific functions. As you press a key, a single audio beep
confirms the key action; every time a key press is not valid, three rapid beeps sound to
indicate that the key action is not valid. There is also a ShuttlePoint knob to move the cursor
across the screen.
The ZOOM IN and ZOOM OUT keys
Pressing [ZOOM IN] shows more detail of a smaller area, by changing the chart scale and
zooming in on your display. Press [ZOOM OUT] to change the scale and show a wider,
otherwise less detailed view. Pressing and holding [ZOOM IN] / [ZOOM OUT] allows for
quick zoom, that is the fast change of the chart scale where only the land areas are drawn.
When
[ZOOM IN] / [ZOOM OUT] is released all chart details are shown.
NOTE
The GPS Chart Plotter contains a Worldwide background that allows you to zoom in to 2NM. For
more detail, a C-MAP B
Y
J
EPPESEN
NT + /MAX C-CARD must be purchased and installed.
The ShuttlePoint knob
The ShuttlePoint knob moves the cursor around the Chart Page (cursor mode) and
highlights menu items. It changes the GPS Chart Plotter from Home mode to Cursor mode
on the Chart Screen. For a detailed explanation of Cursor VS Home mode refer to Par. 3.1.1.
The ENT key
Press [ENT] to select the desired option or to confirm the selection.
The CLR key
When on the Chart Page, press [CLR] to set Home Mode, clear a selected function, leave
a menu, step backwards in a menu or exit a menu.
The MENU key
Selects the Main Menu. When in the Setup Menu mode, moving the ShuttlePoint knob to
the right enters a selection and moving the knob to the left clears the function.
Pressing and holding
[MENU] for 3 seconds allows you to change the fields contained within