Standard Horizon CPF180I, Owner'S Manual

Page: 107 / 166

CPF180i and CPF300i Page 109
13. ADVANCED SETTINGS
The Advanced Setup menu allows customization of many GPS functions, Alarms and
NMEA interfacing.
1. Press
[MENU] , move the ShuttlePoint knob to highlight SETUP MENU and press [ENT] .
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
While in this menu you will see many selections which are described in the next sections.
13.0 INPUT/OUTPUT (NMEA, AIS, RADAR)
13.0.0 Input
The CPF180i has 1 NMEA Input and 2 NMEA Outputs and the CPF300i has 3 Inputs and
3 Output connections.
These ports may be set up to receive and output the following.
· NMEA-0183 - NMEA devices* set to 4800 Baud (default setting)
· C-Com - C-Weather refer to Section 15
· Radar - SI-TEX optional Radar refer to Radar Owner’s Manual
· AIS38400 - AIS Receiver, refer to Section 14
· MOBILARM - Mobil-arm receiver, refer to Section 16
· Disabled - allow the port to be disabled.
NOTE
When a Port is configured, both the Input and Output have the same setting.
Port1 is set to Radar, both the Input and Output wires are set to SI-TEX proprietary Radar
sentences. This means other devices should not be connected to the Input or Output wires.
NOTE*
RS232 not opto-isolated electrical interface
13.0.1 Ouput
The ports may be setup to output NMEA sentences. The table below shows the default
setting each port.
CPF180i
Sentence Port1 Port2
GLL On On
VTG Off Off
BWC Off Off
WCV Off Off
APA Off On
APB Off On
HDG Off Off