11
Installation/routing of pedal straps (OEM and after-market
pedals):
After installing the pedals, you will need to attach the pedals
strap to the strap clamp.
Note: Follow pictures below for
procedure.
Reinstallation of pedals
:
1.
If OEM pedals are being reinstalled after service was
performed, make sure that fair amount of LocTite is applied to
the pedal(s) threads.
2.
If after-market pedals are being reinstalled after service was
performed; apply a fair amount of blue LocTite on the threads of
the pedal(s) prior to installing the pedals on the crank arm/power
meter.
Note: Make sure to clean up the pedal threads as much
as possible prior to reinstallation as this will keep the pedals
from locking up during reinstallation.
3.
If after-market pedals are being reinstalled after service was
performed; LocTite is necessary.
4.
In all cases, ensure that that the pedals are being installed on
the proper side. Pedals should be marked with an “L” and “R” or
in some manner or form indicating which side of the bike they
should be installed on. Start and then tighten the pedals onto the
crank arms/power meter as far as you can by hand, prior to
tightening them with a pedal wrench.
Note: The left pedal will
tighten to the left and the right one to the right. Tighten the
pedal as much as possible, to ensure that it won’t come loose.
Failure to tighten properly will allow the pedal to come loose.
Next Step:
Proceed to the Console Installation section of this SOP.
