13
3.
On top of the handlebar stem, remove the piece of tape
holding the generator wire inside the handlebar stem and lift
it upward, so that it is sticking up.
Note: This step only has
to be done if a new assembly.
4.
Take the console base and route the generator wire
through the bottom of the base (oval hole). Using two (2) of
the screws and two (2) of the washers included in the console
kit, attach the console base to the top of the handlebar stem
(the channel nuts are already installed in the top of the
handlebar stem, so the ones in the kit will be extras). Align the
channel nuts so that you can insert the screws and washers
through the console base into the handlebar stem. If adding a
Media Shelf, see Accessories Installation Section for proper
installation
.
5.
Align the console base so that it sits evenly between the
front and back cover of the handle bar stem (front of console
base should be touching the front cover of the handlebar stem,
but not over). Tighten the console base to the handlebar stem
.
Note: To ensure that the consoles don’t come loose, give the
screws an extra ¼ turn. If you are installing a media Shelf
to a bike, reference the installation instructions in the
accessory section.
6.
Remove the two double battery springs from the back of the
console, leaving only the positive terminal and single negative
spring.
