25
4.
Replace the battery cover and lightly tighten the screw to
secure the cover.
Note: After changing the batteries in the
power meter, it is important to perform an external Zero
Reset. The purpose of external Zero Reset is to ensure the
power meter is calibrated correctly. Please see the External
Zero Reset procedures in this SOP for instructions.
Checking the Batteries in the Console without using the
App:
It is not required for you to replace the lithium battery in the
console unless it goes completely dead.
How to check:
1.
Get on the bike and start riding.
2.
If you see the screen flicker and the console starts to
work, pedal for a min or two.
3.
Stop pedaling.
4.
If the console stays on for a little bit, the battery is good
and just needs to be rode a little longer to charge up more. Note:
if the bike is already in a Customer’s location, m
ove or make
sure that the bike is in a location that it will be rode more to
charge battery.
5.
If the console shuts off right away, the battery is dead and
needs replaced.
If needs replaced:
1.
Separate the console from the base by removing the
thumb screw.
2.
Slightly pull the top of the console upward and off the
base (as there are tabs at the bottom of the console).
3.
Check to see if the generator wire is plugged into the back
of the console.
4.
Check to see if the lithium battery is secure in the back of
the console.
If the console wire is plugged in and the wire is secure and
still not working:
1.
Remove the battery from the back of the old console.
2.
Use a small screw drive to wedge the between the battery
and the side of the console.
3.
Pull the battery out.
4.
Replace the battery.
5.
Plug the console wire back into the battery.
6.
Set the console back onto the base.
7.
Insert thumb screw.
