7
14.
Install the rear stabilizer on the rear of the bike, with
two (2) bolts, four (4) washers and two (2) nuts provided.
Note: When installing the stabilizer, make sure to line up
the bolt holes. Make sure to start the nuts on the bolts by
hand, before applying a wrench to them (to help prevent
cross threading). Tighten, but don’t over tighten the bolts.
If tightened correctly, you should have a slight dimple in the
bottom of the stabilizer. The holes of the stabilizer should
align with the ones on the frame and the angles of the
stabilizer should match that of the bike frame
.
15.
Ensure that all of the leveling legs are screwed all the way
into the stabilizer and turn the bike so that it is resting on both
stabilizers
.
16.
Align the seat of the bike, ensuring that it is parallel to the
floor and in-line with the handle bars. If adjustment is needed,
loosen one nut on the seat clamp, align the seat and retighten.
Note: Make sure that that seat is really tight. Tightness can be
checked by pushing down on the front the seat to make sure that
it won’t move.
Next Step:
Proceed to the Power Meter Installation section of this SOP.
