Chapter 4. Installation
STACK ST8302 and ST8360 Video-Logger System
44
User Guide
Chapter 4 – Installation
No special tools or training are required to install the Stack Video-Logging
System. Before attempting installation you should have set up the equipment
outside the vehicle according to the instructions in Chapter 2 and become
familiar with the configuration menu settings as described in Chapter 3.
Installation begins by installing the wiring harnesses and V/VS module. Once
they are in place you can add the sensors and optional components that came
with your system.
Finally, you should attach a power supply and check that everything is
functioning correctly. Refer to Chapter 5 – Troubleshooting if there are any
problems. If the system appears to be working as expected, you should configure
the various settings to suit your particular vehicle.
The steps you will need to take to install your Video-Logger and related items
will depend on which system you purchased. Use the table below to guide you.
Installation Step
V/VS Module
VS VS V V
Harnesses
Engine Speed (RPM) Sensor
Wheel speed sensor
IR lap timing system
Oil and water temperature
sensors
O O
Oil and fuel pressure sensors
O O
Brake pressure sensor
O O O* O*
Throttle angle sensor
O O O* O*
9
= included O = optional O* = requires brake/throttle sensor harness
Table 7 – Installation steps
